Sanitize the work area.
Verify the functionality of the thermostat.
Ensure proper operation of the system.
Replace commercial air lters both visits. 4 total each visit. (Filter type: 2″ pleated lter Merv13- 20x25x2)
Clean and inspect the blower, blower motor, and blower compartment.
Clean and inspect the coil, pan, and condensate drain.
Check the capacitor and all wiring and connections.
Perform a visual inspection of circuit boards.
Check the power switch or service disconnect.
Verify the availability of appropriate voltage supply.
Ensure proper functioning of all safety mechanisms.
Measure motor amps.
Check for carbon monoxide, smoke detection, and safety measures.
Visually inspect all duct connections.
Verify proper operation of unit.
Clean and inspect the inside of the equipment and coil.
Visual inspection of the fan blades and motor.
Brush out dirt and dust built-up in coils and entire outside equipment.
Make sure all wiring is safe and tightly connected.
Inspect and test the run capacitor.
Check compressor and condenser fan amps and ratings.
Ensure all safety features are connected and functioning.
Inspect refrigerant lines, valves, and ensure proper capping.
Replace V- Belt (Blower Motor Belt) during fall/winter visit.
%20(1).jpg)
%20(1).jpg)
